Near Field Probe Set Com-Power PS-400

I Introducing Com-Power PS-400:

Probe with patented E-field probe The PS-400 near-field probe set is designed to assist in troubleshooting EMI both at the board level and at the component level. It is used to detect radiation from cables, housings, traces and ICs. Typically, a broadband probe is used to determine the general emission area. A probe probe is then used to separate the source into a specific trace or pin. Further analysis can be performed using a contact tip probe (available with the PS-500 probe set) by making direct contact with the curcuit and then tracing the interference to find the cause of the emission. waste such as broken transmission line or impedance mismatch. A typical use of an H-field probe is to verify the integrity of your computer chassis. This is done by moving the probe along the seams of the chassis which can act as slot antennas. This probe is also useful in detecting sources of magnetic noise such as high-current switching circuits or transformers.

II Technical specifications of Com-Power PS-400:

Frequency Range:
H-Field Loop: 9 kHz – 5 GHz
E-Field Broadband: 50 kHz – 5 GHz
E-Field Fine Tip: 100 kHz – 5 GHz
Impedance: 50 Ohm
Connector Type: BNC (f)